Kamov KA-10

[chriswil42]

Never mind the template, how was the language?
Looks good.

Blue yes! Very fiddly - it took several goes to get the two pieces of wire on.

[chriswil42]

I found I had made an error with the rotor assemblies. I'd used the wrong part for the centres. The photos shows the correct patrs. The instruction sheet leaves a little to be desired.

[zak]

Oh, much swearing again no doubt!

[chriswil42]

Oh, much swearing again no doubt!

Yep!

[zak]

Tut, tut, I never swear!

[Bigkev]

I found I had made an error with the rotor assemblies. I'd used the wrong part for the centres. The photos shows the correct patrs. The instruction sheet leaves a little to be desired.

Easily done, is it a easy to rectify?
Bigkev

[chriswil42]

Dropped this from a height of about 4 inches. Now on the shelf of shame while I think about its recovery.

[zak]

Dropped this from a height of about 4 inches. Now on the shelf of shame while I think about its recovery.

Oh no. Is it mendable?

[chriswil42]

With care, I think. When I'm in the right frame of mind.

[MSea]

Keep calm grasshopper - just let the tranquil  thoughts flow through your body and the fingers will do the work - or just throw it against the wall and start another one - hohoho

[chriswil42]

I did think about the bin once or twice.

[chriswil42]

Resurrected from the shelf of shame. After several attempts sticking it all back together, some progress. Just the rotors to finish now.

[chriswil42]

Finished. A reasonable finish in the end. It was a real pig to make.

[zak]

Well done.

[MSea]

You got there in the end Chris- eventually, or at least on the second attempt - it looks great not a bump or blemish to be seen