Quote from: zak on December 12, 2022, 02:38:32 PM
Never mind the template, how was the language?
Looks good.

Blue yes! Very fiddly - it took several goes to get the two pieces of wire on.

I found I had made an error with the rotor assemblies. I'd used the wrong part for the centres. The photos shows the correct patrs. The instruction sheet leaves a little to be desired.

Oh, much swearing again no doubt!

Quote from: zak on December 15, 2022, 02:53:56 PM
Oh, much swearing again no doubt!

Yep!

Tut, tut, I never swear!

Quote from: chriswil42 on December 15, 2022, 02:15:53 PM
I found I had made an error with the rotor assemblies. I'd used the wrong part for the centres. The photos shows the correct patrs. The instruction sheet leaves a little to be desired.

Easily done, is it a easy to rectify?
Bigkev

Dropped this from a height of about 4 inches. Now on the shelf of shame while I think about its recovery.

Quote from: chriswil42 on December 31, 2022, 03:11:00 PM
Dropped this from a height of about 4 inches. Now on the shelf of shame while I think about its recovery.

Oh no. Is it mendable?

With care, I think. When I'm in the right frame of mind.

Keep calm grasshopper - just let the tranquil  thoughts flow through your body and the fingers will do the work - or just throw it against the wall and start another one - hohoho

I did think about the bin once or twice.

Resurrected from the shelf of shame. After several attempts sticking it all back together, some progress. Just the rotors to finish now.

Finished. A reasonable finish in the end. It was a real pig to make.

Well done.

You got there in the end Chris- eventually, or at least on the second attempt - it looks great not a bump or blemish to be seen