Kevin would that be the animal penguins, or the figure from the Batman series - kapow  thwack kapow

Quote from: MSea on August 08, 2021, 10:05:19 AM
Kevin would that be the animal penguins, or the figure from the Batman series - kapow  thwack kapow

No chocolate biscuits of course.

Quote from: zak on August 08, 2021, 11:04:44 AM

Quote from: MSea on August 08, 2021, 10:05:19 AM
Kevin would that be the animal penguins, or the figure from the Batman series - kapow  thwack kapow

No chocolate biscuits of course.

At least they won't melt in the Falklands climate.

Looking really good Bob. It'll be great to see it complete.

Keep at it Bob.

Don't take any notice of our attempts at humour.

It will be another masterpiece from 'Bob'

Bigkev

Once again I've done a bit more, I made a mistake putting the upper and lower hull together so could not fit the Friulmodel tracks over the drive sprocket, I used the kit one's which are not so bad, that must be an excuse to make another early version.

Bob c 

Hi Bob,
That looks nice.
Not sure about the garden worm on the side. ho,ho,ho,ho........
Bigkev

Looks good Bob. Another one in the offing then?

The worm keeps falling off, I don't really want to glue it on because it was removed soon after they landed.

Bob c

Quote from: Bob C on September 17, 2021, 08:50:55 PM
The worm keeps falling off, I don't really want to glue it on because it was removed soon after they landed.

Bob c

What was it Bob? Some form of exhaust?

Quote from: chriswil42 on September 18, 2021, 04:26:26 PM

Quote from: Bob C on September 17, 2021, 08:50:55 PM
The worm keeps falling off, I don't really want to glue it on because it was removed soon after they landed.

Bob c

What was it Bob? Some form of exhaust?

I wondered if it was an air intake?

It was a transmission breather that was removed shorty after landing. I've warmed it up to try to bend it to fit better but it's broken three times already. I don't want to glue it but it might come to that. (It's resin).

Quote from: Bob C on September 19, 2021, 08:08:16 PM
It was a transmission breather that was removed shorty after landing. I've warmed it up to try to bend it to fit better but it's broken three times already. I don't want to glue it but it might come to that. (It's resin).

Yes, resin is a bit brittle.

No doubt you'll show it who's boss!!

no it was the boss I've had to glue it in place.

Bob c