Thanks for the comments guys.
Well moving on, I have now glued the fuselage halves together.
Being a short run kit, there are no locating pins, only the tabs that I attached the fuselage halves earlier in the build. Some misalignment on the two halves namely around the upper fuselage/spine and underside, were evident.
Also the fuselage/cockpit bulkhead would need some filler to fair in.
For the fuselage cockpit bulkhead I used Mr. Hobby tube filler, applied with a spatula. For the rest of the fuselage I used Milliput white. To keep the area of application to a minimum I applied Tamiya tape strips either side of the join, and also some finer strips across the fuselage where panel lines cross the join. This enables these to remain visible and not removed with over enthusiastic rubbing down. As can be seen in one of the pictures gaps in the Milliput where the Tamiya tape has protected these areas.
After a session of rubbing down with sanding sticks and wet'n'dry, got a nice smooth finish. The cockpit bulkhead faired in nicely and will need the paintwork touching in to match the cockpit internals later in the build. Any panel lines that have been lost or lost definition will be rescribed after the wings and tail have been attached.
Some pictures follow:-
Thanks for looking.
Kevin   

Looking very nice.
Kevin

Brilliant!

No the armour was a special one off!
But my spelling may be better than yours.!

Martin the Mean prepares for his next siege, something harder.
The Ballista Boys have been constructing a siege tower for his next adventure.

"Basic and quite ugly and badly formed" - sounds like a committee meeting - hohohhohohohoho

Or Martin the Mean?