3531
« on: January 30, 2015, 08:42:02 PM »
Hi All,
Well now the nose and visor are dry, its time to fill any gaps present and smooth the surface. For the nose /visor I have used a mix of Talc and Thick superglue. This is applied over the gaps and then sprayed with Activator to make it go off.
Notice the windows have been filled with Mr Surfacer 500. This because the replacement decals will portray all the windows. Added with a small brush, once dry will be rubbed down and should reveal neatly filled windows, well that's the theory.
The wings only needed a little rubbing down in the main, any hairline gaps will be addressed once the wings are attached.
The eagle eyed will notice the wheel wells still need to be 'plumbed'. I will get this done a bit later on.
After an initial rub down of the nose area, a few slight depressions were noticed and I have added some 'Green Stuff' to redress these.
Once dry I will rub down again and inspect for flaws.
Bigkev
[attachment deleted by admin]
[attachment deleted by admin]