942
« on: January 17, 2021, 04:34:26 PM »
Second wing fitted. I did this the way I should have done the first by fitting the upper part first then adding the underside, it still needed filler though. If you get the re-tooled newer release the upper wing comes as one piece so you don't have this problem or the ones with the engine nacelles. I think ICM must have had a lot of negative feedback about the kit which caused them to retool.
The tailplane comes as a one piece upper but the instructions would have you fit the actuators through the upper and lower halves before joining these together. No way!!! I cut them in half and added them after.
The infra-red search light had been pre-painted with Tamiya Clear Red and the blanking plate, which isn't mentioned in the instructions, for the nose section fitted before it was joined to the fuselage. Nose windows were masked and a coat of RLM 02 added as some of the inside will be visible. Some blending in is still required.
The engine nacelles were the next to receive the file, fit, file, fit treatment but still need PPP and some filing to get them to start looking correct. Further work is still needed.