Thanks for the comments guys.
Well moving on, I have now glued the fuselage halves together.
Being a short run kit, there are no locating pins, only the tabs that I attached the fuselage halves earlier in the build. Some misalignment on the two halves namely around the upper fuselage/spine and underside, were evident.
Also the fuselage/cockpit bulkhead would need some filler to fair in.
For the fuselage cockpit bulkhead I used Mr. Hobby tube filler, applied with a spatula. For the rest of the fuselage I used Milliput white. To keep the area of application to a minimum I applied Tamiya tape strips either side of the join, and also some finer strips across the fuselage where panel lines cross the join. This enables these to remain visible and not removed with over enthusiastic rubbing down. As can be seen in one of the pictures gaps in the Milliput where the Tamiya tape has protected these areas.
After a session of rubbing down with sanding sticks and wet'n'dry, got a nice smooth finish. The cockpit bulkhead faired in nicely and will need the paintwork touching in to match the cockpit internals later in the build. Any panel lines that have been lost or lost definition will be rescribed after the wings and tail have been attached.
Some pictures follow:-
Thanks for looking.
Kevin   

Looking very nice.
Kevin

Looking good Zak.
Can I ask if 'Neil of the Robin' will be wearing his green tights at the next club meeting......?
Kevin

Hi All,
A little update. The cockpit side walls have been painted and decalled. I used a very dark grey, then applied a coat of 'Kleer'. After this had dried I gave it a wash of heavily thinned black oil paint. Once dry a dry brush with some light grey paint to highlight details.
The floor received a similar finish but I stopped short on the top of the bulkhead as I want to fill any gaps once the fuselage and cockpit interior is all glued in place. A slight difference was that around the rudder pedals and floor I added scratches from a silver coloured pencil where the boots would mark the paintwork.
The instrument panel was painted up. I added the dials individually from some Airscale instrument decals and some Reheat dials too. Those that were too big I just got a suitable size punch and die and punched the centre part I wanted. A few dots of colour added, admittedly using personal choice to add intrest.
All the above now need a sealing coat of Satin Varnish, and the the fuselage halves joined.
Some pictures follow, thanks for looking.
Kevin
 

Yes WELCOME Brian.

Nice to have you on board!

Kevin

Well Done Chris.
You have made a good job of this one despite it giving you problems all the way. It certainly looks like a 'Clog' that has seen active service.
Nice work and a thumbs up from me!
Kevin

Hi Zak,
Thanks for taking and posting the pictures.
It was a very good meeting. The Demo by Wayne was very interesting and I'm sure we all got something out of it.
Some very nice models on the table including a nice Waterloo diorama........
Bob's entry was a worthy winner amongst some very stiff competition.
Kevin

It was most impressive Bob.
Full of character and attention to detail. I liked it a lot.
Kevin