There is now a nice one in 1/35 with the launch trailer and a Hanomag tractor - can't remember who it is by? (IBG?) I will endeavour to find out.
Well its Takom.

That would be one big kit, but an impressive one set in a diorama.
Cheers,
Bigkev

Okay,
A little more progress made.
The conning tower platforms have has the flagstaff added, the front of the conning tower has had the support for the D/F loop put in situ (later to be added from wire)
The cable cutter at the bow added.
Now a dry run to see how it all looks more or less complete construction wise, the deck gun. the radar antenna, and periscopes placed in situ prior to painting.
As it progresses, I am more and more pleased with the model.
Next stage:- Painting the Model
Some pictures of the above follow.
Cheers,
Bigkev

Hi All,
Well a little more progress on the sub.
The hull has been primed with Mr Surfacer 1500 from a spray can. It showed up some area's that required more attention. The Rudder assembly in the kit was poorly fitting so I had built up some of the braces from brown styrene rod. The primer showed where my work needed a little filling and fettling. A few dabs of Mr Surfacer 500 was applied here and there and will be rubbed down.
The conning tower had been assembled and the gun platforms thinned in preparation for the etch brass fittings.
Talking about the etch brass, I took a few small pieces of etch brass railing (kindly supplied by Haddock)and played around with them, bending, curving, and glueing them to a piece of plastic card.
For me I found a mix of superglue and Gator Grip Thin worked for me. Though the superglue application on such minute bits caused me problems. I know the initial attempt might seem a little rough, and I'd agree. However, I think I will be able to use the etch brass in the kit now. 
I attach some photos of the above. Next instalment soon.
Cheers,
Bigkev

Well I won't stoop so low.
I'll be the 'Sole' of discretion.
Sorry Couldn't help myself.
Bigkev

Move over Gordon Ramsey and Mary Berry, there's a new kid on the block!

Well Done Wizzel!

They are very...............sweet!

Look forward to seeing them on the deck, ready to leap into action.

Well, the Sea-Pigs probably, the 'Stringbag' look a likes probably more like me in the morning creaking, but inside raring to go....................well, sometimes!
Bigkev

Sorry to nit pick Roger.............

But that third cable from the right should be brown............

ONLY JOKING!!

A brilliant model from the Modelling Hanger of Roger S. , Once again!

Now what about OV-10D? in 1/32
Bigkev

Hi Zak,

If anyone is going to make this kit a worthy representation, it is you.

Bigkev