P4015923.jpg Compressor 0.jpg DSC_0015.JPG

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Bob C

Pages: [1]
1
Modelling Projects / dingo Scout Car
« on: November 16, 2020, 08:11:49 PM »
This is going to be my next project whilst waiting for some bits to arrive to finish the Cromwell, it's a MiniArt Dingo I bought at a model show last year.
If you've forgotten model shows are where you get up in the middle of the night drive to the location set up walk about have a chat spend lots of cash pack up drive home wait for the next one and repeat, those where the days.

2
General Discussion / Bling Bling
« on: October 24, 2020, 12:43:22 PM »
Hi all
I found these a while back at Boyes, I can't remember how much they cost but it could only have been a couple of pounds.
I found they work well on 1/35 scale armoured vehicles as searchlight/headlight lenses but sure they would have other uses.

3
Modelling Projects / Tamiya 1/48 F-16C
« on: October 15, 2020, 11:49:28 AM »
Started this Tamiya F-16C sometime ago, I've decided to carry on with the project.
Decals will be Eagle Strike productions for an Aviano based aircraft in 2000. Lets see how far I get.

4
Modelling Projects / Cromwell
« on: October 05, 2020, 08:03:50 PM »
As promised this is my new project, once again it's Tamiya's 1/35 scale Cromwell with Accurate Armour conversion set to turn it into a F type hull, which requires various parts of the upper hull to cut and replaced with resin parts. I will post the turret later. This is it so far.

5
Modelling Projects / Tamiya Cromwell
« on: October 04, 2020, 11:35:54 AM »
Finished this a couple of days ago. It's the Tamiya 1/35 scale Cromwell MK IV, this one is slightly different in that it has an Accurate Armour split drivers hatch which allowed the driver to escape when the turret was traversing. it's in the marking of the 8th Hussars which was the armoured recce unit of 7 armoured division.
painted in my usual way with Tamiya, Hataka and ammo mig paints.
I have another two Cromwell and an ARV to do.

6
Modelling Projects / Tamiya 1/35 scale Centaur CS MK IV
« on: September 04, 2020, 08:31:00 PM »
This is my latest kit. It's Tamiya's Centaur Close Support (CS) MK IV, straight out of the box except for the gear on the back, the water can holder and spare track on front all come from various sources. Painted as normal with Humbrol, Tamiya and Hataka paints. It's mark as Centaur of the Royal Marine Armoured Support Group (RMASG).

7
Modelling Projects / Cromwell MKIV
« on: May 16, 2020, 02:06:08 PM »
This is my next project, will try to remember to post a few from the build.

8
Modelling Projects / Cruiser A(Close Support(CS)
« on: May 16, 2020, 02:02:25 PM »
This is my Bronco Cruiser A9CS, in the markings of 3RTR in France May 1940, good kit if a little over engineered.
The 3 Tankie figures are Gecko early war British tank crew with Ultracast heads.
The French farmer and cart from Tamiya.
The base seen before is from Miniart.
Painted mainly with HATAKA.

9
Modelling Projects / Messerschmitt Bf 109E3
« on: April 14, 2020, 01:14:23 PM »
Hi all this is my completed Tamiya 1/48 Me109E3.
it's the original one that came out in the early 90's I think, I started it at the time then it was put on a shelf and not bothered with, apparently it has some issues with the front end, so Tamiya corrected it.
Painted with a brush, with Xtracolour, Xtracrylic and Aeromaster. Decals by Southern EXPO.
Just for something different.

10
Modelling Projects / Crusader MK III
« on: April 09, 2020, 09:44:00 AM »
Good morning
Here is my latest WIP, it's the 1/35 scale Tamiya/Italeri Crusader MK III, bought by my wife for Christmas a couple of years back,

11
Modelling Projects / Universal Carrier
« on: April 02, 2020, 02:48:10 PM »
1/35 Tamiya Brengun carrier built for next weeks club night.

Pages: [1]